Commit 734e00fa authored by Phil Reid's avatar Phil Reid Committed by David S. Miller
Browse files

net: stmmac: socfgpa: Ensure emac bit set in System Manger for PTP



When using the PTP fpga to hps clock source for the stmmac module
the appropriate bit in the System Manager FPGA Interface Group register
needs to be set. This is not set by the bootloader setup  when the
HPS emac pins are being for this emac module.

This allows the PTP clock to be sourced from the FPGA and also connects
the PTP pps and ext trig signals to the stmmac PTP hardware.

Patch proposed by Phil Collins.
Signed-off-by: default avatarPhil Reid <preid@electromag.com.au>
Signed-off-by: default avatarDavid S. Miller <davem@davemloft.net>
parent e2726020
......@@ -34,6 +34,9 @@
#define SYSMGR_EMACGRP_CTRL_PHYSEL_MASK 0x00000003
#define SYSMGR_EMACGRP_CTRL_PTP_REF_CLK_MASK 0x00000010
#define SYSMGR_FPGAGRP_MODULE_REG 0x00000028
#define SYSMGR_FPGAGRP_MODULE_EMAC 0x00000004
#define EMAC_SPLITTER_CTRL_REG 0x0
#define EMAC_SPLITTER_CTRL_SPEED_MASK 0x3
#define EMAC_SPLITTER_CTRL_SPEED_10 0x2
......@@ -148,7 +151,7 @@ static int socfpga_dwmac_setup(struct socfpga_dwmac *dwmac)
int phymode = dwmac->interface;
u32 reg_offset = dwmac->reg_offset;
u32 reg_shift = dwmac->reg_shift;
u32 ctrl, val;
u32 ctrl, val, module;
switch (phymode) {
case PHY_INTERFACE_MODE_RGMII:
......@@ -175,12 +178,19 @@ static int socfpga_dwmac_setup(struct socfpga_dwmac *dwmac)
ctrl &= ~(SYSMGR_EMACGRP_CTRL_PHYSEL_MASK << reg_shift);
ctrl |= val << reg_shift;
if (dwmac->f2h_ptp_ref_clk)
if (dwmac->f2h_ptp_ref_clk) {
ctrl |= SYSMGR_EMACGRP_CTRL_PTP_REF_CLK_MASK << (reg_shift / 2);
else
regmap_read(sys_mgr_base_addr, SYSMGR_FPGAGRP_MODULE_REG,
&module);
module |= (SYSMGR_FPGAGRP_MODULE_EMAC << (reg_shift / 2));
regmap_write(sys_mgr_base_addr, SYSMGR_FPGAGRP_MODULE_REG,
module);
} else {
ctrl &= ~(SYSMGR_EMACGRP_CTRL_PTP_REF_CLK_MASK << (reg_shift / 2));
}
regmap_write(sys_mgr_base_addr, reg_offset, ctrl);
return 0;
}
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment