uniphier-regulator.txt 1.83 KB
Newer Older
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Socionext UniPhier Regulator Controller

This describes the devicetree bindings for regulator controller implemented
on Socionext UniPhier SoCs.

USB3 Controller
---------------

This regulator controls VBUS and belongs to USB3 glue layer. Before using
the regulator, it is necessary to control the clocks and resets to enable
this layer. These clocks and resets should be described in each property.

Required properties:
- compatible: Should be
    "socionext,uniphier-pro4-usb3-regulator" - for Pro4 SoC
16
    "socionext,uniphier-pro5-usb3-regulator" - for Pro5 SoC
17
18
19
20
21
22
23
    "socionext,uniphier-pxs2-usb3-regulator" - for PXs2 SoC
    "socionext,uniphier-ld20-usb3-regulator" - for LD20 SoC
    "socionext,uniphier-pxs3-usb3-regulator" - for PXs3 SoC
- reg: Specifies offset and length of the register set for the device.
- clocks: A list of phandles to the clock gate for USB3 glue layer.
	According to the clock-names, appropriate clocks are required.
- clock-names: Should contain
24
    "gio", "link" - for Pro4 and Pro5 SoCs
25
26
27
28
    "link"        - for others
- resets: A list of phandles to the reset control for USB3 glue layer.
	According to the reset-names, appropriate resets are required.
- reset-names: Should contain
29
    "gio", "link" - for Pro4 and Pro5 SoCs
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
    "link"        - for others

See Documentation/devicetree/bindings/regulator/regulator.txt
for more details about the regulator properties.

Example:

	usb-glue@65b00000 {
		compatible = "socionext,uniphier-ld20-dwc3-glue",
			     "simple-mfd";
		#address-cells = <1>;
		#size-cells = <1>;
		ranges = <0 0x65b00000 0x400>;

		usb_vbus0: regulators@100 {
			compatible = "socionext,uniphier-ld20-usb3-regulator";
			reg = <0x100 0x10>;
			clock-names = "link";
			clocks = <&sys_clk 14>;
			reset-names = "link";
			resets = <&sys_rst 14>;
		};

		phy {
			...
			phy-supply = <&usb_vbus0>;
		};
		...
	};